Parts interchange for the Gen 1 Zed.
SUSPENSION / STEERING
- 03-04 ZX6R
- 05-06 ZX6R
- 04-07 ZX10
** ZX10 2008 forks are too long and will not work.**
Triples. You can use the 03-04 ZX6R Triples. The Z stem will press right into the ZX6r Triples.
You can use the ZX6R Stem but it is shorter and you can only get one lock nut to work. <--Not recommended
You can not mix the 636 lower triple clamp with the Z upper. The sweep and width is different.
If you use the 636 triples be prepared to have custom wheel spacers machined as the 636 triples will set the forks wider apart.
- 03-05 ZX6R
Mods Required: The '05 636 shock will NOT directly bolt in. The lower legs on the 636 shock are 2mm closer together, and there is a spacer inside the shock linkage which will not fit into it. Need to have 1mm milled out of the inside of each shock leg to get it to bolt in.
- '05 ZX10R
Mods Required: I've personally got one, just haven't installed it yet. Mods TBD...
- 01-04(?) GSXR600
Mods Required: Minor clearance probs, slightly too short
- 98-02 zx6, zx9, and zx12
- ZX9 or ZX6
Mods Required: None required
- ZX10R Wave Rotors - fronts DO NOT fit, the mounting holes are offset
- z1000(03-06), ZX12R(05-07), and ZR-7S(03-05) front brake rotors are all the same
-ZX9R (02-04)320mm front rotors
No mods required direct bolt on
- 2001-2003 GSXR 600/750/1000 calipers
Mods Required: May require creative brake line routing or longer hoses
**If running the ZX6R Front End**
Pay attention to which brake set you get. 03-04 Look the same as 05-06 but if 05-06 brakes are used on the 03-04 Forks you will need to add 10mm Spacers on the caliper bolts. And will not work the other way. the 03-04 brakes will not have enough contact on the 05-06 forks set.
- Cams ('98-'03)
Mods Required: There's a few things required for this. Here's a great thread on it: