• Stephen Parr shared a link to the group: The Kawasaki ZZR1100 Appreciation Society.

    This any good Peter?

    • Yep that's the one for the ZZR 1100.

    • I purchased one of these aftermarket ones a few years ago. Whoever thinks about buying one needs contact me first regarding a small but simple issue with them

    • If you're fitting one of these to a D, you'll need to wire in a resistor of course.

    • That's what I was on about. 1/4 watt resistors available at maplin electronic for pennies

    • You may also find the wires on the aftermarket ignition unit are a little shorter than you need ..

    • 200ohm resistor the ones i got from maplins were all duff

    • I brought a load of them and tested each one. No problems